![]() ![]() The square and the vertical line were drawn with the mouse. ![]() draw a line with the command line, cannot select and trim itĪttached is a minimal example that shows the problem. draw a line with the mouse, can select and trim it In the same layer, I can perform these actions sequentially: This has nothing to do with the layer being locked. If I save my drawing, quit LibreCAD, re-start LibreCAD, and re-open my document, I still cannot ever select items that were originally drawn with the command line. This behavior persists across app sessions. A line should not behave differently based on how it was drawn. "pl 0,0 200,0 0,200 close" cannotĮver be selected (either as the limiting entity or as the entity to trim) and cannot be trimmed. all lines that are drawn with the command line, e.g. I can select and trim lines that are drawn with the mouse using the "2-point" method Using LibreCAD Mac version 2.2.0-rc1-254-g9f2c32dd this is what I found: Tools_instructions.pdf Last but not least, if you want to break your block back into the various original entities, select your block and click on the Explode tool in Modify.I see similar problems selecting objects as OP. I am working at the moment on an instruction document for all the drawing tools, it is not complete yet but I join here a PDF version of what exists: I suggest that you read the following document for more on that. If you want to save this block for future use you need to make sure you save it in the block list. Your block is created, now all the entities you selected are just one unit. Once you click on the point chosen a small window will open: "Block Settings", it will ask you for a Block Name, give it a name and OK it. Specify a reference point (you will need it if you copy it somewhere else). Once you have selected all the entities you need to join, select the tool "Create a Block", it looks like a rectangle with a circle in the lower left corner and a green point in the lower right. The problem here will be that I use a later version of LC: Version: 2.1.0-alphaįirst it does not matter if you are in isometric or not, LC is just a 2D CAD program. ![]() ![]() But it does not work! So I must have missed a step! I thought if you use Modify> move/copy, then click on the object and them move the mouse to a desired location and click again. How to you copy an object and then use a mouse to drop it at location pointed by mouse? There is no marker to show where to align the selected object with a desire drop location.ģ) Then I move the mouse pointer to the desire place.īut the position of the mouse pointer is not the position where the selected object is dropped.Ī) How do I joint all the parts into one object when in isometric mode?ī) The way I am doing the copy above is probably wrong and it is cumbersome. The selected objects (now a duplicate) turns white. I do not know how to joint all the objects into one object.ġ) I select with mouse all the objects by drawing a rectangle over the region.Īnd use the mouse to reselect the entire blue area. Then I like to click the object and it would select all the object.Īfter that I lie to copy and paste them at various locations with mouse. I like to group or join this objects into one. I have an ellipse with some lines and circle inside the ellipse in isometric drawing mode. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |